I just recieved my Pathfinder. Power level 1 on pedal assist is a little too slow for me. When I bumpt up to power level 2 the bike takes off at about 17 mph. How can I adjust what percentage jump each power level makes?
I just recieved my Pathfinder. Power level 1 on pedal assist is a little too slow for me. When I bumpt up to power level 2 the bike takes off at about 17 mph. How can I adjust what percentage jump each power level makes?
As for Pathfinder series models, the PAS levels are coded at the factory at the very beginning and can't be changed later by the customers. If you use it for daily travel or commute, we suggest you use PAS 2 or 3. If you use it for off-road travel or hill climbing, we suggest you use PAS 4 or 5. PAS 1 is only used for saving battery power before you arrive at your destination when you come to a situation where the battery is going to run out soon.
I have the same problem I think thats not a very helpful answer I also have a hemiway and the pa can be adjusted
Just Got the Adventurer and I'm having similar experience... Pedaling along on PA 2 and get a minimal amount of assist, but if I bump it up to PA 3 the bike goes full throttle??? Looking for adjustment to the SW900 and can't find an answer to this problem... Would like to reset the SW900 to factory settings butr can't find out how to do that... One video says to go to P18 to reset but my SW900 only goes up to P17??
I have the Bee Ranger, each PAS is ok,
1 is about 5mph
2 is 11.5 - 12 mph
3 is like 18
4 and 5 ar FAST even if I'm in gear 7 its hard to keep up.
I would like to see Throttle on demand no matter what PAS you are in. if pullining up to a 4 corner and have the green light it would be nice to give throttle to cross the road a little faster. My other E bike does.
